6. Place the last end cap electrode on the quartz spacer cone side in. The
banana plug should be on the same side as the lower end cap.
7. Place the last quartz spacer on the end cap electrode. Be sure the spacer is
seated completely flat on the end cap.
8. Place the oven top on the electrode stack with the gold connectors on the
same side as the lower half. Check the oven and quartz spacers. There
should not be any gaps. If the quartz is a very tight fit, try placing the quartz
into the trap oven before putting the trap oven on the electrode stack.
NOTE: The gold connectors on the trap ovens should line up on the same side.
The banana plugs should be visible in the notches in the trap oven and should be
seated all the way to the end of the grooves in the trap oven. If there is a gap,
disassemble and recheck the alignment of the spacers and electrodes.
68 of 127
Summary of Contents for 4000 GC
