•
To adjust the height of the mudguards, change the fixing screws or the shafts
to the other holes.
In addition, the mudguards can be inclined forward and backward in their
fixing holes.
The tightening torque of the fixing screws is 70 Nm.
IMPORTANT: According to the EU directives the smallest allowed distance
between the side of the tyre and the mudguard is 40 mm and between the
top of the tyre to the mudguard is 60 mm.
NOTE:
The distance between the fixing screws must be as wide as possible. Use the
highest and lowest possible holes for the fixing screws.
4.8.10
Valtra LHLink
4.8.10.1 Calibrating the Valtra LHLink
Calibration has to be carried out if the steering angle position sensor has been
changed or the Valtra LHLink does not centre to the middle position. Under
normal conditions you do not need to perform the calibration.
WARNING: If the left and right direction are not calibrated in the right
order, the Valtra LHLink turns to the opposite direction.
1. Start the engine.
2. Activate the auxiliary hydraulics.
3. Turn the turning ratio controller knob and offset pivot controller to the centre
position.
4. Maintenance
- 464 -
Summary of Contents for Versu N Series
Page 1: ...OPERATOR SMANUAL NSERIES Versu Ref no 39 893 21 3 08 2015 YOUR WORKING MACHINE...
Page 2: ......
Page 517: ......