Utax CDC 1930, User Manual

Page: 345 / 588

Default Setting (System Menu)
9-39
9
Manual Staple
The following settings can be configured in the manual staple settings.
NOTE:
When a 4,000-sheet finisher is not installed, these settings cannot be configured.
Manual Staple
Select whether or not to set the setting for Manual Staple. The table below shows the available settings.
Use the procedure below to select the default setting for Manual Staple.
1
Press the System Menu key.
2
Press [Common Settings] > [ ] > [Next] in Manual Staple > [Change] in Manual Staple .
3
Select the default setting for Manual Staple.
4
If you selected [On] in 3, set the time until manual stapling mode is automatically cancelled. The setting
range is 5 to 60 seconds (5-second increments).
5
Press [OK].
Staple Position
Set the default Staple Position. The table below shows the available settings.
Use the procedure below to select the default Staple Position.
1
Press the System Menu key.
2
Press [Common Settings] > [ ] > [Next] in Manual Staple > [Change] in Staple Position .
3
Select [A4 Long Edge] or [Letter Long Edge].
4
Press [OK].
• Manual Staple
• Staple Position
Item Description
Off Manual stapling cannot be used.
On Manual stapling can be used.
Item Description
A4 Long Edge Staple on the long side of A4 size.
Letter Long Edge Staple on the long side of letter size.