Revision: 1.00
Copyright 2015 U.S. Robotics Corporation
16 |
P a g e
For all SIM card based operators
The network settings populate automatically for most SIM cards. Scroll down to the Network
Settings section and check the
APN
,
Username
, and
Password
fields. Update if necessary and
click
Save changes
. If the service plan requires a PIN code, scroll down to the PIN Settings
section, enable and enter the PIN code, and click
Save changes
.
Related Topics
Configuring the Base Unit
3G Connection Tab
Installing Expansion Cards
Gateway
expansion cards
are easy to install either during staging by a distributor or system integrator,
or in the field by a technician.
Expansion cards are designed to fit in one of two expansion slots accessed from the unit’s front or back
panels. In general, cards with antenna interfaces, such as the WLAN card, are installed in the back slot to
avoid interference with the 3G antennas on the front of the base unit.
To install an expansion card:
1.
Make sure the unit is powered off.
2.
Using a T6 Torx screwdriver, remove the three screws from the bottom plate on the front or
back panel, and remove the plate.
3.
With the expansion card in your hand, make sure the English labelling for any external
interfaces, such
WLAN Antenna
or
Serial Port
, are facing up. In this orientation, the card
connector is also right facing.
Tip:
Another way to determine the appropriate slot, is to look at the card connector. Cards with the
small connector are installed in the rear slot. Cards with the large connector are installed in the front
slot.
