Ulvac UTM3400 Series, Instruction Manual

Page: 63 / 102

6.6 Software Operation
49
6
6.6
Software Operation
NOTICE
Settings data can be read and written via serial interface, but cannot be read or written via
remote control connector.
Software functions are indicated in Table 6-2 below.
Table 6-2 Software Operating Functions
Function Descripition
Status Operation mode LOCAL, REMOTE or the other communication
means
Rotational Speed
Motor current
Run Status
(Note 1)
MB Sensor Magnet bearing Sensor output value
Unbalance Rotor unbalance monitor
Operation START Acceleration
STOP Deceleration
ALARM reset Reset operation when alarm occur
Timer Run time Timer and Counter Monitoring and reset
maintenance timer
Power failure touch-down count
High-speed touch-down count
MB warning count
Setting Variable Rotation Speed
(Low SPEED) Changes or sets pump rotation speed.
Remote-control connector Signal Sets actions for remote-control signals
Warning output Sets external output for warning events
Of the alarm codes listed in Table 9-7 "Table of
Warnings", this setting changes the actions for
warnings with alarm code 86 to 95, as
indicated below
・
Status orange lamp flashes
・
Alarm event set via serial communication
・
Remote control "WARNING" ON
RS-485 Sets communications environment
Multidrop setting
Network ID setting
History ALARM history