Turbo Ace MATRIX
74
FIXED ID BIND for Walkera Devo 10 transmitter
Setting up a Fixed ID bind between your MATRIX and Devo 10
IMPORTANT:
When adjusting the settings of the MATRIX (while it is turned on),
make sure that the propellers are removed and that the unit is securely tied down
before proceeding in order to avoid any accidental flight.
Please ignore this step if you have a Futaba or Spektrum transmitter/receiver
Start by plugging in the Walkera bind plug (comes with receiver, if purchased)
to the “batt.” port on the receiver, followed by plugging in the battery for the
MATRIX. The red light on the receiver should blink rapidly. Wait for the MATRIX’s
connection tune to finish playing, then proceed by unplugging the bind plug (the red
light should now blink at a slower pace); followed by the battery.
NOTE:
The transmitter does not need to be on for this step.
Setting up the Fixed ID on your transmitter
First go through the steps to bind the MATRIX to your transmitter (1. Turn on
the transmitter 2. Plug the battery into the MATRIX 3. The MATRIX is bound when
the red light on the receiver turns solid). From the home screen of the transmitter, go
into the Main Menu screen and select: Model Menu
Fixed ID
turn Status to
“On”
set the ID code to your desired value and hit enter. You will see a little menu
saying “ID Match.” After the menu disappears, unplug the MATRIX battery,
followed by the transmitter and you’re done!
IMPORTANT:
ALWAYS turn off the transmitter AFTER unplugging the
MATRIX). Now your MATRIX will only bind with only the transmitter that you have
set up the fixed ID bind with.
