Turbo Ace MATRIX
28
If you are experiencing difficulties in handling the aircraft, it may be because it is not
in GPS or Attitude Mode.
You may skip the following setup instructions if you have purchased the Turbo Ace
MATRIX with a transmitter radio, as we have already completed all the setup for you.
If you have purchased a MATRIX without a radio, please see the following to make
sure your radio is setup correctly.
Setting up and checking Turbo Ace MATRIX flight mode for GPS or Attitude
Mode.
Plug in a 3 pin cable connector to the "INPUT" channel U of the NAZA flight
controller. Connect the other end of the cable to the GEAR output on your receiver
with the brown wire closest to the edge of the receiver casing (If you have a receiver
other than a Walkera WK2801-PRO, Devention or Spektrum, please check your
receiver manual for polarity).
MATRIX with GPS module (Assign GEAR to 3 position toggle switch, WOW
default MIX switch for Devention 10):
Go to your radio setup, press ENT
Model Menu
Device Output
assign GEAR to
MIX SW (MATRIX without GPS). This means that every time the
MIX
switch is
flipped forward on your radio, it will toggle the GEAR output of the receiver and tell
the controller to perform GPS Mode. If you own a Walkera radio, the gear channel in
the radio should be changed from normal to REVERSE (Please refer to section 4.2
Transmitter Calibration, for detail adjustment for GPS/Attitude/Manual mode) You
can use the NAZA Assistant Software to double check the MIX switch operation after
you have completed the above setup.
Turn on your transmitter radio (Warning: Always tie down the MATRIX and remove
all propellers when you perform any setting changes to the transmitter or NAZA
Assistant Software. Failure to do so may cause serious issues, as the MATRIX motor
may start up if an incorrect value is entered). Connect the provided Programming
USB-to-Micro USB cable from your PC computer’s USB port (XP or WIN7) to
Micro USB port on the MATRIX communication port (on the LED side panel of the
MATRIX). Please connect this cable after the transmitter is bound to the receiver.
Double click on the NaZaInstaller.exe located in the provided 8GB USB flash drive to
install the NAZA ASSISTANT SOFTWARE
