Turbo Ace MATRIX
24
SWITCH’s midpoint by pressing the L or R button until “A” segment turns
blue.
(5)
Flip the MIX SWITCH forward (away from you). If the “GPS” segment turns
blue then skip to Step #7.
(6)
If the “GPS” segment does not turn blue, press ENT on your
transmitter
Function Menu
Travel Adjust
Gear. Use the UP/DN button
to select -100.0% and adjust your GEAR SWITCH’s endpoint by pressing the
L or R button until “GPS” segment turns blue.
(7)
Flip the MIX SWITCH backward (towards you). If the “M” segment turns
blue then skip to Section 4.2.11.
(8)
If the “M” segment does not turn blue, press ENT on your
transmitter
Function Menu
Travel Adjust
Gear. Use the UP/DN button
to 100.0% and adjust your GEAR SWITCH’s endpoint by pressing the
L or R button until “M” segment turns blue.
(9)
If FIXED ID BIND is used, transmitter can be turn on and off to bind and
re-bind, which will make fail safe testing easier (see Section Fixed ID Bind).
To test Fail-Safe, press ENT on your transmitter
Function Menu
Fail
Safe
Gear. Use the UP/DN to adjust the Fail-Safe setting for Gear to around
-44% and turn off transmitter to check/test if fail safe turn blue on screen (if
fail safe does not turn blue, re-bind the transmitter and adjust Fail-Safe setting
for Gear until fail safe turn blue while transmitter is off.) This procedure will
make sure fail-safe is active while transmitter is off or circumstances signal
lost during flight.
AUTO PILOT
(1)
BASIC PARAMETERS: Recommend setting for Pitch set to 130%, Roll set
to 120%, Yaw set to 90% and Vertical set to 120% and ATTITUDE GAIN is
Pitch set to 100% and Roll set to 100%. REMOTE ADJUST is set to INH.
Basic Gain and Attitude Gain should never set to lower than 90%, otherwise
crash might result.
(2)
ENHANCED FAILED-SAFE METHODS (GPS module is required). The
recommended settings for enhanced failed-safe methods are GO-HOME and
LANDING. (Please refer to DJI NAZA User Manual’s page 21 for enhanced
failed-safe methods).
(3)
INTELLIGENT ORIENTATION CONTROL (IOC): (GPS module is
required). Check the box next to “3. Intelligent Orientation Control”. If GPS is
installed, the settings for Devention 10 and RX 1002 are as follows. Assign