Turbo Ace MATRIX
73
(15)
If the motor direction is correct, go to the next step. If the motor direction is
incorrect, you may have made a mistake. Check your connections and make
necessary corrections. Two wires connected incorrectly will cause the motor to
spin in the wrong direction. Now tidy up the wires by pushing them back into the
extension arm. For reverse the motor direction, just swap 2 motor wires on the
ESC.
(16)
If you make any changes, always repeat the tie-down flight tests in Section 5.1
until you are satisfied that everything is operating properly.
(17)
Very important! Before attaching the carbon landing skid plates to the CNC
brackets, please first make sure the inner CNC bracket is secured to the anchor
shoulder bolt. If the carbon landing skids plates are installed first, it will cause
the anchor bolt to misalign and possibly strip the CNC bracket screw hole.
(18)
Attach the carbon skid plates on both sides of the inner and the outer CNC
brackets with the 6mm screws.
