Turbo Ace MATRIX
54
4.4 Receiver, Flight Controller & Auto-stabilization Setup
FIGURE
4.4
(1)
Connect Channel #A wire from the flight controller to the channel 1 of the
receiver.
(2)
Connect Channel #E wire from the flight controller to the channel 2 of the
receiver.
(3)
Connect Channel #T wire from the flight controller to the channel 3 of the
receiver. Watch for polarity.
(4)
Connect Channel #R wire from the flight controller to the channel 4 of the
receiver.
(5)
Connect Channel #U wire from the flight controller to the channel 5 of the
receiver.
(6)
Connect Channel #X2 wire from the flight controller to the channel 6 of the
receiver.
(7)
Connect Gyrox Brushless gimbal tilt control cable to the channel 7 of the
receiver.
(8)
Connect Channel #X3 wire from the flight controller to the LED Versatile
Unit (PMU).
Setting up MATRIX to ensure a smooth flight with GPS or Attitude mode
To ensure the smooth flight of your Turbo Ace MATRIX, please make sure that you
setup and fly the MATRIX in GPS or Attitude mode. In order for GPS or Attitude
mode to function, first it is important to make sure the mix switch on your radio is all
the way forward. Please refer to Section 4.2 Transmitter Calibration. If you are