Turbo Ace MATRIX
66
6.2 MATRIX CAMERA MOUNT SERVO CONTROL SETUP
Figure 6.1-1
MATRIX Camera Mount Plate and Shock Plate
IMPORTANT
: Only digital servos are compatible with the Naza flight controller.
Using an analog servo will cause malfunctioning, produce loud buzzing noises and
burn up the servo. A light buzzing sound from a digital servo is, however, normal.
The MATRIX features built-in gyros for camera mount auto compensation so there is
no need to purchase separate gyros for your camera mount.
6.2.1 How to set your camera TILT (PITCH) auto compensation control for the
MATRIX-S flight controller, receiver and transmitter
Connect flight controller F2 to tilt (pitch) servo.
Connect receiver’s (For Walkera Devo 10 is Aux 4, For Spektrum DX8 is Aux 3, or
Futaba 14SG is channel 7) Channel (assuming the AUX4 channel has not been
already used for flight mode control or other functions) to flight controller’s X1 using
a 3 wire cable with the black ground wire closest to the edge of the flight controller
(some receivers’ polarity for ground may be different, so see your receiver manual for
more details). Go to AUTOPILOT tab in DJI NAZA Assistant Software to set all
remote adjustments to INH, and go to the GIMBAL tab to click ON to enable the
gimbal manual control. Additionally, when you tilt the MATRIX forwards or
backwards, the MATRIX gyro will sense the tilt so the camera mount servo will also
automatically compensate for that by pitching the camera in the opposite direction to
