Turbo Ace MATRIX
47
(1)
Very important: Remove all 4 propellers from the motors for safety.
(2)
Double check to make sure all ESC connectors are marked/labeled (#1
through #4 matching the connectors on the flight controller #1 through #4)
so that you will be able to keep track of the corresponding connectors when
you need to put them back later.
(3)
Disconnect all 4 ESC connectors from the NAZA flight controller so they
may not interfere with each other’s programming.
(4)
Move the throttle stick all the way down. Now turn on the transmitter.
(5)
Disconnect X3 on NAZA flight controller and plug into port 8 on the
receiver.
(6)
Turn on Futaba radio
double tap “LNK”
go to “Reverse”
go to THR
and set it to “REV”
(7)
Insert one of the labeled ESC connectors into the receiver’s throttle channel
(wow default port 3) port while watching for the correct polarity. Black/dark
brown wires are usually on the edge of the receiver. Please verify polarity in
your receiver manual if you are not using the stock receiver.
(8)
Move the throttle stick all the way up.
(9)
Within 3 seconds, connect the battery to the MATRIX’s battery plug (The
MATRIX battery plug is still connected to all 4 ESCs but only one ESC
should be connected to the receiver at a time.)
(10)
When the ESC makes 1 beeping sounds, immediately move the throttle stick
all the way down. The ESC will then make 2 beeping. (If you did not hear
the 1 beeping sounds when entering programming mode or you did not hear
2 beeping after the ESC have completed its programming then you need to
move throttle all the way down and disconnect the battery from the
MATRIX battery plug and repeat from step #7 to #10 for the ESC.) If you
did not experience any problems, then you have completed programming on
this ESC which now retains the high and low end point data in its memory.
Disconnect the battery from the MATRIX’s battery connector then
disconnect the ESC connector from the receiver.
(11)
Repeat this process for each ESC from Step#7 through Step#10. Please
make sure you have programmed all 4 ESCs by starting from the #1 labeled
ESC and finishing with #4 labeled ESC. Your transmitter power should
remain in the power on position throughout the entire process of
programming all 4 ESCs.
(12)
After you have successfully re-programmed all 4 ESCs, unplug the battery
from the MATRIX battery plug
