Turbo Ace MATRIX
21
4.2 Transmitter Calibration for Transmitter (Required Setup For
ARF)
Video Instruction:
How to set up your transmitter calibration for MATRIX:
https://www.dropbox.com/s/s4vhtkqq1v3r0px/How%20to%20set%20up%20your%20
transmitter%20calibration%20for%20X830.MP4
How to set up your autopilot and voltage setting for MATRIX:
https://www.dropbox.com/s/vfaa6tcf8v4qdc2/How%20to%20set%20up%20your%20
autopilot%20and%20voltage%20setting%20for%20X830.MP4
If you have purchased your MATRIX with a transmitter (RTF package) please skip
this section because we have already completed the calibration. If you are using a
transmitter that has never been paired with your new MATRIX, you will need to
calibrate your transmitter to the MATRIX flight controller using the following
procedure. Any change to the quadcopter or setting change to the transmitter might
require transmitter calibration.
(1)
Very important!! Remove all 4 propellers from the motors for safety.
(2)
Tie down your MATRIX
(3)
Turn on your transmitter radio.
(4)
Connect battery to the MATRIX battery connector.
(5)
Connect the provided Programming USB Cable from your PC computer’s
USB port (XP or WIN7 or WIN8) to the Micro USB port on the MATRIX
communication port (on the LED side panel of the MATRIX). (If the
computer does not recognize the USB, the USB driver is located in the
provided 8GB USB flash drive)
(6)
Double click on the NAZAInstaller.exe located in the provided 8GB USB
flash drive and install the NAZA ASSISTANT SOFTWARE.
(7)
Double click on the application file named NAZA ASSISTANT
SOFTWARE. Wait for the program to start up.
(8)
Click
MOUNTING
Use to input the distance between GPS and Main Flight
Controller.
(9)
Click
MOTOR MIXER
MIXER TYPE: Please select
Quad-rotor X
and remember to click WRITE
after you update any settings (WRITE is #7 on top of FIGURE 4.2)
(10)
Click
TX CALI