Turbo Ace MATRIX
48
(13)
Now reverse the throttle back to normal on Futaba radio
double tap
“LNK”
go to “Reverse”
go to THR and set it to “NORM”
(14)
Insert the 4 ESC connectors, labeled #1 through #4 back to corresponding
M1 through M4 ports on your NAZA flight controller. The black/dark
brown wire (-) for each of the ESC connectors are closest to the red NAZA
label of the flight controller.
4.2 Transmitter Calibration for Futaba 14SG Transmitter (A
Must Setup For ARF)
Video Instruction:
1.
How to connect Futaba RX and setup Futaba TX for Matrix:
https://www.dropbox.com/s/vztqrvhplxq3h80/2.%20Futaba%20RX%20Setup.MP4
2.
How to set up fail safe for Futaba transmitter for Matrix:
https://www.dropbox.com/s/63n1ylwy4lnvl7y/6.%20Futaba%20Control%20Mode%2
0Failsafe.MP4
3.
How to set up Futaba transmitter calibration for Matrix:
https://www.dropbox.com/s/wws2w6pyba91ra9/5.%20Futaba%20TX%20Callibration
.MP4
4.
How to set up the gain setting for Matrix:
(Default setting is not recommended for carry heavy equipment)
https://www.dropbox.com/s/2pkkn3ipc73tbwy/7.%20Gain%20Setup.MP4
5.
How to set up advanced setting for Matrix:
https://www.dropbox.com/s/76vv670q6jb99lu/8.%20Advanced%20Setup.MP4
6.
How to set up the voltage setting for Matrix:
https://www.dropbox.com/s/clsrg9ixxp8b2xn/9.%20Voltage%20Setup.MP4
If you have purchased your MATRIX with a transmitter (RTF package) please skip
this section because we have already completed calibration. If you are using a
transmitter that has never been paired with your new MATRIX, you will need to
calibrate your transmitter to the MATRIX flight controller using the following
procedure. Any change to the quadcopter or setting change to the transmitter might
require transmitter calibration.
(1)
Very important!! Remove all 4 propellers from the motors for safety.
(2)
Tie down your MATRIX
(3)
Turn on your transmitter radio.
(4)
Connect battery to the MATRIX battery connector.
