Turbo Ace MATRIX
27
4.4 Receiver, Flight Controller & Auto-stabilization Setup
FIGURE
4.4
(1)
Connect Channel #T wire from the flight controller to the THROTTLE
channel of the receiver. Watch for polarity.
(2)
Connect Channel #E wire from the flight controller to the ELEV channel of
the receiver.
(3)
Connect Channel #A wire from the flight controller to the AILE channel of the
receiver.
(4)
Connect Channel #R wire from the flight controller to the RUDDER channel
of the receiver.
(5)
Connect Channel #U wire from the flight controller to the GEAR channel of
the receiver.
(6)
Connect Gyrox brushless gimbal tilt control cable to the AUX 4 channel of the
receiver.
(7)
Connect Channel #X2 wire from the flight controller to the AUX 1 channel of
the receiver.
(8)
Connect Channel #X3 wire from the flight controller to the LED Versatile
Unit (PMU).
Setting up MATRIX to ensure a smooth flight with GPS or Attitude mode
To ensure the smooth flight of your Turbo Ace MATRIX, please make sure that you
setup and fly the MATRIX in GPS or Attitude mode. In order for GPS or Attitude
mode to function, first it is important to make sure the mix switch on your radio is all
the way forward. Please refer to Section 4.2 Transmitter Calibration. If you own a
Walkera radio such as the Devo 10, you will need to reverse the gear channel in your
radio so that when you flip the gear switch forward, it enables GPS or Attitude Mode.
