Turbo Ace MATRIX
55
experiencing difficulties in handling the aircraft, it may be because it is not in GPS or
Attitude Mode.
You may skip the following setup instructions if you have purchased the Turbo Ace
MATRIX with a transmitter radio, as we have already completed all the setup for you.
If you have purchased a MATRIX without a radio, please see the following to make
sure your radio is setup correctly.
Setting up and checking Turbo Ace MATRIX flight mode for GPS or Attitude
Mode.
Plug in a 3 pin cable connector to the "INPUT" channel U of the NAZA flight
controller. Connect the other end of the cable to the Channel 5 output on your receiver
with the brown wire closest to the edge of the receiver casing (If you have a receiver
other than a Walkera, Devention or Spektrum, please check your receiver manual for
polarity).
MATRIX with GPS module (Assign Channel 5 to 3 position toggle switch, WOW
default SB switch for Futaba 14SG):
Turn on the Futaba 14SG, double tap “LNK”
scroll down to “Function” press
“RTN”
scroll down to channel 5
Change CTRL to “SB”. This means that every
time the
SB
switch is flipped forward on your radio, it will toggle the Channel 5
output of the receiver and tell the controller to perform GPS Mode. For Futaba radio,
you might need to change from normal to reverse on the AUX 1 channel in your radio
so that when you flip the SB switch forward on the radio, you are activating the GPS
mode. The reason to setup the radio this way is to ensure everything is in the correct
default mode when all the switches on your radio are all the way forward (away from
you). You can use the NAZA Assistant Software to double check the SB switch
operation after you have completed the above setup.
Turn on your transmitter radio (Warning: Always tie down the MATRIX and remove
all propellers when you perform any setting changes to the transmitter or NAZA
Assistant Software. Failure to do so may cause serious issues, as the MATRIX motor
may start up if an incorrect value is entered). Connect the provided Programming
USB-to-Micro USB cable from your PC computer’s USB port (XP or WIN7) to
Micro USB port on the MATRIX communication port (on the LED side panel of the
MATRIX). Please connect this cable after the transmitter is bound to the receiver.
