泰智科技
Shenzhen Topwisdom Technology Co., Ltd
70
complete times, default power ,speed of the machine., the water protect status ,the
speed of key moving, and the position of axis x and axis y. And at the bottom left of the
interface, it show the machine status and the last working time.
The parameters are described below:
Network status:
If connect the network, it’ll show the IP address196.168.0.100.
Otherwise, it shows Network disconnect.
Complete:
The complete times of the selected file.
Power1:
The power of Laser 1. The above value is min power value. The following
value is the max power value.
Power2:
The power of Laser 2. The above value is min power value. The following
value is the max power value.
Speed:
It shows the work speed.
Valid:
The water protection status. In the figure, the water protection is 1X: 2X, 1X
means water protection 1 not connected, 2X means water protection 2 not
connected. If connect, it’ll show 1V:2V.
Key Speed:
Manually move axis speed, can press the ―Select‖ key to change the
speed, there are ―Fast‖, ―Middle‖, ―Slow‖.
PX, PY:
The coordinate in the current place.
When there is no file Selected, It displays the default power and speed. When
selecting the file, it shows the power and speed in the first layer of the file. When
processing, it shows the power and speed of the current processed layer.
When the machine is processing, if you want to modify the speed of the current layer,
press the pause button, then press speed button, you can modify the speed of the
current layer. In the same way, press power button to modify the min/max power. If
machine is processing, press ―Left/Right‖ button, can immediately reduce or increase
the laser power. Press once, plus or minus 1%. Left for reduce, Right for increase.
When changed the speed of power during working operation, after the completion of
processing, it prompts whether to save the changes of the speed and power value.
In standby mode, press
to clear the completed number of selected file. If the
focus length was set in laser parameter interface, press
to auto focus. If the
firmware version is V.L010.16 or later which is for camera cutting machine, press the
to start lable cut.
