泰智科技
Shenzhen Topwisdom Technology Co., Ltd
39
The two most important parameter settings are Outline output and Carve output. If
neither of the two is selected, ―output disabled‖ will be shown, i.e., no engraving output
for this kind of drawings will be carried out; if both are selected, data in this color will be
provided with possibility of both Outline and Carve output, pay attention that there must
be closed drawings for Carve. Otherwise, select one of them for one output condition.
PrecisionUnit
: the unit of precision of engraving.
DPI(dots/inch): dots per inch
DPM(dots/mm): dots per millimeter
SpeedUnit
: the work speed and the free speed unit.
m/minute: meter per minute
mm/s: millimeter per second
PRI
: Is used for setting the engraving order of different colors, the smaller PRI, the
earlier to be exported, and vice versa.
Those are common settings for colors. ―Outline‖ and ―Carve‖ menus are respectively
corresponding to settings for Outline and Carve. For Outline, there are settings for
engraving features including speed, power intensity etc., for dots, the dotting time
settings are also available; and the settings for Carve follow the same way.
When the check box of ―default‖ is selected, no need to set the power intensity and
speed and the default values of the machine will be adopted; settings for power
intensity and speed are only available in case the check box of ―default‖ is not
selected.
Parameters description:
Output:
When selected, engraving output for drawings in the current color will be
carried out.
Min. Power:
When stroking curves, this power intensity applied for line start and the
corner of the curve .Or it applied for the top depth when gradient carving. The range is
0.00-100.00% (Min.Power1 is setting for min power of laser1, Min. Power2 is setting
for min power of laser2. Max. power is similar).
Max. Power:
When stroking curves, this power intensity is applied as the work speed
was reached. Or it applied for the bottom depth when gradient carving. The range is
0.00-100.00%. If the is elbow too deep, it means the Min. power intensity is on the high
side or the speed is on the low side. When gradient carving is carried out, the min
power must not be set bigger than 30%, the max power can be set bigger, for getting a
better degree of gradient carving effect. The gradient rang is 0-3mm.
Work Speed:
The work speed of the laser head is cutting. The rang is 0.000 to Axis
X,Y limit speed.
