泰智科技
Shenzhen Topwisdom Technology Co., Ltd
41
Y_Unilateralism: Engraving from one vertical side, when move inversely ,the laser
is off. It can eliminate backlash and the processing effect is good, but the
processing time is longer.
Y_Bidirectional: Engraving from both vertical sides. The processing time is short.
But because the machine generally exist backlash leads to dislocation. At this time
you need to set up a backlash or backlash list.
Gradient(mm):
the gradient length of gradient engraving, as shown in figure below.
When carry out gradient engraving, the top depth is determined by the min power. The
larger the min power, the deeper the top depth. The Depth from top to bottom is
determined by the max power. The larger the max power, the deeper the depth. The
gradient length determines the distance from the top to the bottom, the greater the
distance, the slope more flat.
Fig. 4-5
Precision:
the precision of engraving. The unit is DPI or DMP. It means how many
lines will be processed per inch or per millimeter. For example, 500 DPI means it will
process 20 lines within 1 millimeter length. The greater the precision value, the deeper
the engraved depth.
ReverseRepair:
use to compensate the backlash of the machine. The debug step is
as follows.
Draw three 50X50 rectangle in CorelDRAW, select the carve output check box in
parameter setting window. And set precision as 2 DPI, ReverseRepair as 0. Then
output the file to control card.
The actual processing effect is similar to the figure below. The length of first line
and second line dislocation in the middle rectangle is the compensated length.
Generally it is negative, according to the engraving effect to set it. As the figure
shown below, the length is -0.2mm. So the ReverseRepair is -0.2.
Fig. 4-6
