泰智科技
Shenzhen Topwisdom Technology Co., Ltd
65
between the line sections, so the order cannot the arranged. Therefore, when drawing,
pay attention that the joints must be closed.
No display when opening the drawing in a 3rd party engraving software, or run into a
wall when using CAD for direct output.
For example, you draw a drawing in CAD, which looks normal, while it cannot be
displayed in a 3rd party engraving software, or run into a wall when exported to the
equipment. Why? This is normally caused by a small drawing or dot far away from the
drawing, which is not what the user expects to process but is just drawn by mistake,
this makes the whole drawing to be so large and cannot be seen when opened in
another software after zooming out, and the breadth of output will be far exceeding the
operation breadth of the equipment, which will also cause problems.
Part of the drawings of CAD direct output or in DXF files cannot be displayed and
processed
AutoCAD2005 is newly provided with region tools and table tools, parts of a closed
drawing can be processed into the drawing of a region via the region tools on the left.
Then the software cannot recognize and process it, so pay attention that there should
not be any region drawing when drawing, if there are some, they should be redrawn by
line sections or curves or be broken up with breakup operation. Tables drawn with the
table tools should follow the same way, they can be normally exported after being
broken up, those are all new features after AutoCAD2005.
