泰智科技
Shenzhen Topwisdom Technology Co., Ltd
44
Select a serial number in the shape drop-down box. Then the shape with this number
will be displayed in the upper right window. And the red arrow shows the start process
point and the direction of cutting.
Show Order:
Select show order check box. The serial number of the shape will be
shown side by the shape in the upper left window.
Auto Order:
click the auto order button, the program will automatically optimized
cutting sort all shapes.
Step:
Specify the start processing point of the shape. The unit is the line number.
When set the step as 1, click the ―StartPos‖ button once, the start processing point will
move forward 1 line segment on cutting direction.
Sequence:
Specify the process order of the select shape. Set the proper value of
sequence, then click ok button. At this time, the upper left window will display the new
processing order of shapes (the Show Order check box is selected).
Enter Line:
When Selected the enter Line check box, an extension line will be added
before the shape. It is used to avoid the laser light is not stable, lead to processing
problems. Set into the angle and length of enter line, click ok button below to complete
setting.
Out Line:
When Selected the enter Line check box, an extension line will be added
after the shape. It is used to avoid laser burn twice at the same place of the start
position of close shape, lead to overcut problem. Set into the angle and length of out
line, click ok button below to complete setting. Generally, the enter line and the out line
is less than 10mm.
When finish setting, click the ok button in right bottom to save the configure.
4.1.4 Single Axis Operation
Click the ―AxisControl‖ button in Fig. 4-2, a track setting window will be shown. It can
separately operate the single axis moving, show as Fig. 4-10:
