Chapter 4: Using the web interface
98-126882-B
Managing LAN network users
83
•
Bridge mode
is an exclusive connection, with NAT disabled. Use this mode together with a
network classification entry that selects a single computer (see
Using the network
classification table
on page 87). This mode is not available in the Default user group.
•
No internet access
means no connection to the Internet is allowed. Use this setting e.g. for
IP handsets, where an Internet connection is not required. The external voice connection is
still available; this setting only affects communication over the Internet.
6.
Select
Dynamic IP address
.
This is the IP address used externally on the satellite network.
If you want to use a
static IP address
, and your subscription allows for it, you must still leave
this setting at
Dynamic
. Then select
SIM default
in step 8. and type in the APN user name and
password from your provider in step 9.
Your terminal will then use the static IP address set up for your SIM card.
7.
Set
IP Header compression
to
Enabled
or
Disabled
.
For information on IP Header compression, see
Header compression
on page 90.
8.
Select the source of the
APN
(Access Point Name).
There are four options for setting the APN. Unless you have special requirements, it is
recommended to use the SIM default, or to set the common APN to SIM default, and then
select Common here. You have the following options:
•
Common
. The APN is taken from the Common APN defined under
SETTINGS > Common. Refer to
Setting the common interface settings
on page 67.
•
SIM default
. The APN is taken from the SIM card. If you want to use a static IP address on
the external network, select this option either here or in the Common setting.
•
Network assigned
. The APN is assigned from the network.
•
User defined
. Type in the APN. APNs are provided from the Airtime Provider.
9.
If your APN uses a password, type in the user name and password provided from the Airtime
Provider.
10. At
Automatic activation
select whether the profile selected in the next step should be
activated automatically or manually.
•
Disabled
means you can activate/deactivate the profile from the Dashboard.
•
Enabled
means the profile is activated automatically.
11. Select the
Primary profile
.
Select a profile from the
Primary
scroll list. This profile is used by this network user group as a
first choice, when possible.
Note
Typing in a static IP address is currently not supported by the BGAN network.
Note
If you are going to use the static IP address from your SIM card, the user name and
password are mandatory! See step 6. above.
Note
If the selected primary profile is a Streaming profile, this setting has no effect.
Streaming profiles must always be activated manually from the Dashboard.
Summary of Contents for Explorer 727
Page 1: ...JH G B6CJ6A MEADG G...
