ThermoFisher Scientific HERASAFE 2030i Series, Operating Instructions Manual

Page: 50 / 173

| Start-up
40
|
50155215 Herasafe 2030i / Maxisafe 2030i
Chapter 5
The “Setup completed” screen appears with its “Finish” button highlighted,
prompting you to complete the setup, as shown in Figure 22 below.
Figure 22 Initial Setup: Completing the Initial Setup
11. Tap the “Finish” button to have your setup stored.
The unit comes up in standby mode, as shown in Figure 23, with the window closed.
Figure 23 Main Screen - Unit in Standby Mode, Window Closed
The Setup is complete now. You can now begin using the unit.
Setup completed
Step 5 of 5
Back Finish
NOTE All of the settings made in the previous steps can be edited by tapping
the “Settings” icon in the left-hand Main Navigation Bar. See “Main Navigation
Bar (Region R3)” on page 49.
Power supply connection
The safety cabinet should remain connected to the power supply system at all times
to ensure that settings for the individual unit configuration remain active in the
memory. If the power supply is interrupted for more than 5 minutes, the time must be
reset correctly. After the power supply connection has been reestablished, the
system switches to the operating mode that had been active last. Additionally, a
window with the message
“
Mains voltage has been restored
”
appears as soon as
power has been restored, prompting the user to confirm by tapping OK. This
message may, for example, be caused by a power outage.