ThermoFisher Scientific HERASAFE 2030i Series, Operating Instructions Manual

Page: 66 / 173

| Operation
56
|
50155215 Herasafe 2030i / Maxisafe 2030i
Chapter 6
When the front window reaches the working position, the movement stops
automatically. When the movement starts above the working position, the front
window stops at the maximal opening position.
Proceed as follows to stop the upward movement:
2. Tap the “Close window” button .
Proceed as follows to continue the upward movement beyond the working position:
3. Tap the “Open window” button .
Lowering the Front Window
Proceed as follows to lower the front window:
1. Tap the “Close window” button on the Control panel and keep it depressed until
the window reaches its closed position.
Proceed as follows to stop the downward movement:
2. Release the “Close window” button .
Switching the Sample Chamber Illumination on and off
In each operating mode but the UV disinfection cycle, the sample chamber illumination
can be switched on or off.
Proceed as follows to switch the illumination on or off:
1. Tap the “Light Bulb” button to switch on or off.
The illumination comes on, and the “Light Bulb” button is displayed with a light
gray border.
Activating and Deactivating the internal Power
Supply Receptacles
All power outlets in the sample chamber can be activated (power supply on) or
deactivated (power supply off) simultaneously.
Proceed as follows to activate the power receptacles:
1. Tap the “Power Receptacle” button .
The powered accessories in the sample chamber are turned on, and the “Power
Receptacle” button
is displayed with a light gray border.
Proceed as follows to deactivate the power supply receptacles:
2. Tap the “Power Receptacle” button .
The powered accessories in the sample chamber are turned off, and the light gray
border on the “Power Receptacle” button
disappears.
NOTE The working position is factory pre-set and cannot be changed in the Settings.