ThermoFisher Scientific HERASAFE 2030i Series, Operating Instructions Manual

Page: 142 / 173

| Maintenance
132
|
50155215 Herasafe 2030i / Maxisafe 2030i
Chapter 10
Sample Chamber Illumination
The tubes are installed in the front cover bezel.
1. Remove the bezel retaining screws and the bezel.
2. The tubes are retained by rotatable sockets. Rotate the tube carefully to the removal
position and remove it from the socket.
3. Insert the replacement tube and rotate it to the working position.
4. Reinstall the bezel and secure it with the screws.
Replacing the Front Cover Seal
Figure 117 Replacing the Front Cover Seal
The seal is merely pushed onto the device frame and is secured additionally at the upper
and lower side of the sample chamber opening by a retaining rail.
1. Remove the retaining screws [2] and remove the retaining rail [3].
2. Pull the seal [1] off the retaining lip at the device frame.
3. Push the groove of the replacement seal onto the retaining lip and press the seal on
to ensure that it is positioned flush along the entire length of the contact surface.
4. Install the retaining rail.
NOTE
If the front door seal [1] shows visible signs of wear, the seal must be replaced
by the service.