Thermo Scientific GENESYS 10S Vis, User Manual

Page: 29 / 134

3
Accessories
Installing the Internal Printer (Optional)
Thermo Scientific GENESYS 10S Vis User Guide 21
See “Cell Holder Configurations” on page 15 for the different cell holder accessories that can
be created for your instrument.
Each of the Cell Holders needs to be installed on either a single-cell baseplate or a multi-cell
baseplate by removing the cell holder(s) secured to the baseplate. Each cell holder has a captive
screw in the bottom of the holder that secures the holder to the baseplate. Use a flat blade
screwdriver to loosen the captive screw from the baseplate and lift the cell holder from the
baseplate. Then insert the new cell holder into the appropriate position and secure it to the
baseplate by tightening the captive screw.
See “Installing the 6-Position Cell Holder and the Single Cell Holder” on page 19 for
instructions on installing the complete accessory assembly in your instrument.
Installing the Internal Printer (Optional)
Note To use 100 mm long pathlength cells, you must install the Single Cell Holder
baseplate.
Note You can install only three each of some accessory cell holders. Be sure to place them
in positions B, 2 and 4.
Note Remove the baseplate from the instrument before removing or installing cell
holders.
CAUTION Avoid shock hazard. Turn off the instrument and disconnect the power cord
from the outlet before installing the internal printer.
Captive screw on lamp door
Removing door from hinge
Hinge
Connecting wires to printer