16
Absorbance Ratio
Setting Up Test Parameters
72
GENESYS 10S Vis User Guide
Thermo Scientific
2. Highlight the test to recall and press
Enter
.
This screen provides these capabilities:
•
•
•
• Viewing the list of stored tests
•
Setting Up Test Parameters
Y
To set up test parameters
1. In the Absorbance Ratio screen, highlight the desired parameter.
2. When the parameters are set, press
Save Test
to save the test or
Run Test
to measure a
blank or samples.
Measuring Samples
Y
To measure samples automatically (using Auto 6 or Auto 3)
1. Install the blank and samples.
Note
If Cell Correction is ON, you must run the Setup Correction application before
you can access Run Test or Measure Samples.
Note
If Auto Save Data is ON, you must enter a Data File Name before you can
access Run Test or Measure Samples.
Summary of Contents for GENESYS 10S Vis
