TEUPEN LEO 27T, Translation Of The Operating Instructions

Page: 217 / 312

Faults
07/05/2018 217
Code Description
41 The machine has been pivoted too far with narrow bracing or the resolver transducer is faulty.
42 The machine has been pivoted too far with single-sided wide bracing or the resolver transducer is faulty.
43 The machine has been pivoted too far with wide bracing or the resolver transducer is faulty.
44 The maximum swivel range has been exceeded or the resolver transducer is faulty.
45 Pivot angle verification error. Check the resolver transducer or calibrate the angle sensors.
46 Check the position of the angle sensors. It may be necessary to reset to zero or reset.
47 The telescopic boom is set too wide or the resolver transducer is faulty.
48 Check the pressure sensors.
49 Check the pressure sensor to make sure the values are reliable.
50 The pressure measured is too low for this situation. The telescopic boom is braced or the pressure sensor
is faulty.
51 The "Telescope boom telescoped in" position switch is defective.
52 Software error / hardware error.
53 Software error / hardware error.
54 Hardware error SPI- Real Time Clock.
55 The machine has not been switched off for several days and needs to be restarted.
56 The input information for the safety functions between the master and slave is different.
57 The input information for the safety functions between the master and slave is different.
58 The input information for the safety functions between the master and slave is different.
59 The input information for the safety functions between the master and slave is different.
60 Check safety relay 1 monitoring contact.
61 Check safety relay 2 monitoring contact.
62 Check safety relay 3 monitoring contact.
63 Check safety relay 4 monitoring contact.
64 The telescopic boom was set too wide or the resolver transducer is defective.
65 The load curve has been saved incorrectly. Check the load curves and save them again.
66 The load curve deviates too far from the base curve. Check the load curves and save them again.
67 The values of the load curve are faulty. Check the load curves and save them again.
68 The angle values in the load curve do not match the specifications. Check the load curves and save them
again.
69 The number of outrigger positions does not match the specifications. Check the load curves and save
them again.
70 Error when checking the load curve. Check the load curves and save them again.
71 Error when calculating the load limit. Check the load curves and angle sensors on the telescopic boom.
72 Max. current of basket scale exceeded, check basket scale.
73 Max. current of basket scale below target, check basket scale.
74 The valid measuring range for the basket scale has been exceeded. Check the basket scale.
75 The basket scale supplies different values. Check the basket scale.
76 Software error.
77 Calibration values from the outputs faulty. Check the values or load the factory settings.
78 Software error / hardware error.
79 Software error / hardware error.
80 Joystick values faulty. Check the joysticks and their parametrisation.
81 Joystick values of radio remote control faulty. Check the radio remote control.