TEUPEN LEO 27T, Translation Of The Operating Instructions

Page: 220 / 312

Faults
220
07/05/2018
Code Description
162 EEPROM memory content faulty. Machine type is not set
163 A length sensor has sent an invalid length value.
164 Length sensor verification error. Check or calibrate length sensor.
165 The maximum speed for raising or lowering the telescopic arm has been exceeded.
166 The maximum speed for swivelling has been exceeded.
167 Joystick 5 on the control panel was moved during start-up or is faulty.
168 The position switch for monitoring the middle position of the working basket or the angle sensor on the
working basket is faulty.
169 The switch for activating the special function on the lower controller has been actuated or is faulty.
170 The collision switch on the control panel was actuated during machine start-up or is faulty.
171 Check the CAN node in the chassis / check the external CANopen bus.
172 Check the inputs for the 'lower boom applied’ position switch.
173 Check the inputs for the ‘lift boom holder erected’ position switch.
174 Check the inputs for the ‘lift boom holder applied’ position switch.
175 Tilt sensors for the bracing angle provide different values. Check the sensors.
176 The foot switch was actuated while starting up the machine or is faulty.
177 The pressure switches or the valve for releasing the brake are faulty.
178 The pressure switches or the valve for releasing the outriggers are faulty.
179 A length sensor on the upper boom has sent an invalid length value. Check the length sensor.
180 Speed sensors for the travel speed provide different values. Check the sensors.
181 The pressure sensors for measuring the floor pressure provide an invalid value. Check the pressure
sensors.
182 The current of the pressure sensors has dropped below the minimum level.
183 The maximum travel speed has been exceeded.
184 The upper and lower boom is raised too high while the lift boom holder is not erected.
185 Last fault entry (number does not appear)