TEUPEN LEO 27T, Translation Of The Operating Instructions

Page: 219 / 312

Faults
07/05/2018 219
Code Description
124 Check inputs for the "Small working height" position switch.
125 The USA enabling button has been actuated whilst starting up the machine or is faulty.
126 Check the inputs of the 'lower boom' position switch.
127 Check the inputs for outrigger locking function for outrigger 1.
128 Check the inputs for outrigger locking function for outrigger 2.
129 Check the inputs for outrigger locking function for outrigger 3.
130 Check the inputs for outrigger locking function for outrigger 4.
131 Lower boom angle verification error. Check the resolver transducer or calibrate the angle sensors.
132 The maximum lower boom angle has been exceeded or the resolver transducer is faulty.
133 Differential angle verification error. Check the resolver transducer or calibrate the angle sensors.
134 The maximum upper boom angle has been exceeded or the resolver transducer is faulty.
135 The offset value has exceeded the permitted range. Check and re-calibrate the resolver transducer for
the lower boom.
136 Joystick 3 on the cable remote control was moved during start-up or is faulty.
137 Joystick 4 on the cable remote control was moved during start-up or is faulty.
138 Check tilt sensor for working basket level / Check external CANopen bus.
139 Check tilt sensor for working basket level / Check external CANopen bus.
140 The tilt sensor for the basket level supplies different values. Check the sensor.
141 The maximum tilt angle for the basket level has been exceeded. Check the sensor or the working basket
level controller
142 The tilt sensor for the basket level is faulty. Check the sensor.
143 Invalid parameters for activation of the basket level. Perform parametrisation.
144 Software error / hardware error.
145 The rotary angle sensor on the working basket is faulty. Check the sensor and supply line.
146 The minimum upper boom angle has been exceeded or the resolver transducer is faulty.
147 The minimum differential angle has been exceeded or the resolver transducer is faulty.
148 The maximum differential angle has been exceeded or the resolver transducer is faulty.
149 The minimum lower boom angle has been exceeded or the resolver transducer is faulty.
150 The lower boom may only be lowered if the limit switches "lower boom telescoped in" are actuated.
151 The offset value has exceeded the permitted range. Check and re-calibrate the resolver transducer.
152 Check the inputs for the position switch 'upper boom applied'.
153 The measured angle must not exceed a certain value whilst the upper boom is applied. The position
switch in the support may be stuck.
154 The offset value has exceeded the permitted range. Check resolver transducer of the upper boom and
calibrate again.
155 The position switch for the upper boom telescoped in position is faulty.
156 The switch for activating the home function on the control panel has been actuated or is faulty.
157 Tilt sensor for the basket level has transmitted an invalid measured value. The measured value is outside
the measuring range.
158 The differential angle has been exceeded whilst the lower boom was raised or the resolver transducer is
faulty.
159 The differential angle has been exceeded whilst the lower boom was raised or the resolver transducer is
faulty.
160 Last error entry (number does not appear)
161 The rotary sensor or CAN node on the working basket is faulty.