Teledyne SierraNet M408, User Manual, Page: 79 / 248

SierraNet M408 User Manual 71
Trigger Filter Settings in Easy Mode Teledyne LeCroy
5. After the project runs, you see an analyzer trace capture display (see Figure 2.50 on
page 71 ).
Figure 2.50: Analyzer Trace Capture Display.
For details about the results display, see “Display Manipulation” on page 113 and see
“Preferences” on page 149 .
2.7.3 Patterns and Data Capture Setup
You can refine data capture by choosing Pattern and then selecting specific patterns for
capture. Additionally, you can define a different set of patterns to capture after trigger.
The Trigger and Filter settings dialog allows you to set the parameters for triggering on
selected triggers and filtering in (including) or filtering out (excluding) selected patterns.
Refer to “Trigger Filter Settings in Easy Mode” on page 64 .
2.7.4 Pre- and Post Trigger Data Capture
Move the Trigger Position slider button (see Figure 2.40 on page 63 ) to define one set of
patterns for capture prior to the occurrence of a trigger (left of the slider) and another set
of patterns for capture after the occurrence of a trigger (right of the slider). The selection
and setup procedure is the same for both Pre ‐ Trigger capture and Post ‐ Trigger capture.
(see “Trigger Setup” on page 101 ).
2.7.5 Triggering/Filtering Patterns (Easy Mode)
The application provides User Patterns and a library of Preset patterns.