Teledyne SierraNet M408, User Manual, Page: 109 / 248

SierraNet M408 User Manual 101
Trigger Filter Settings in Easy Mode Teledyne LeCroy
Figure 2.78: Protocol Errors Dialog
Select the desired protocol errors or click on the Check All box to select all the errors.
Enter the count of the expected number of occurrences. Check the Check All box to select
ports P1 through P8 or individually select ports.
2.7.10 Trigger Setup
You can specify when the analyzer triggers. Two trigger modes are available: The default
mode is Snapshot or you can select Event Trigger.
When data capture starts with Don’t care (Snapshot) selected, the analyzer triggers on
the first data pattern on the bus.
Starting a data capture with Pattern selected triggers when specific pattern(s) are
detected in the captured data stream. The following three ways can trigger the analyzer
with Pattern selected:

Trigger on any pattern (Any Trigger Mode)

External Trigger

Trigger on a sequence of patterns (Sequential Trigger Mode)
Snapshot Mode
To trigger immediately on any pattern, check the Snapshot button.