Teledyne SierraNet M408, User Manual, Page: 59 / 248

SierraNet M408 User Manual 51
Analyzer Settings Teledyne LeCroy
Device Settings
The Device Settings dialog allows you to configure Probe Calibration and the External
Trigger settings for each device. See “Probe Calibration” on page 51 and “External
Trigger” on page 58 for more information.
2.6.2 Probe Calibration
In the Device Settings dialog, select the Probe Calibration Settings tab. Depending on the
project's protocol configuration, the Device Settings tab appears slightly different. These
settings are meant for advanced users to tune the performance of the Analyzer's receiver
ports, the Jammer's receiver and transmitter ports, and the Analyzer's DUT link pass ‐
through path. In most cases, the default settings will perform well and should be used as ‐
is.
40 GigE Configurations
Figure 2.22: Device Settings dialog for 40 GigE device.
You can manually calibrate the probe settings. Set the parameters for the following:

Cable Type: Select Optical, 1m Copper or 3m Copper.

RX Eq DC gain: Select a value from the drop ‐ down list.

RX Eq Control: Select a value from the drop ‐ down list.

Advanced: Selecting Advanced displays the Advanced Probe Setting dialog. (See
Figure 2.23 .) Enter the desired values for each of the parameters.

Splitter: Selecting Splitter displays the Splitter Settings dialog. (See Figure 2.24
on page 52 .)

Apply Selected Settings to All: Applies the settings selected in the currently
selected port to all ports in the list.