Teledyne SierraNet M408, User Manual, Page: 198 / 248

Teledyne LeCroy InFusion Scenarios
190 SierraNet M408 Protocol Analyzer User Manual
Inject General Error FEC Parity Error Injects a FEC error into traffic.
Sync Header Error Injects a Sync Header error into traffic.
Invalid 10 ‐ bit ‐ Error
Code
Injects invalid 10b code into the line (FC8
only).
Running Disparity
Error
Injects a Running Disparity (RD) error into
traffic(FC8 only).
Insert Insert New Frame Allows to insert a whole frame as specified
from the list of available frames.
Symbol (66 Bit) Allows to insert a Symbol 66 bits.
Insert Bytes Allows to insert Bytes (FC 16 only).
Ordered Set Jam Delete Delete an Ordered Set Jam.
Remove [Replace
with IDLE]
Remove an Ordered Set Jam or Replace
with another Ordered Set.
Replace with
Another Ordered
Set
Only replace with another Ordered Set.
Scenario Execution Stop Scenario Stops the current Scenario. This Action
should be the only Action in a State as it
has higher priority over other Actions.
Restart All
Sequence
Restart all sequences in the Scenario.
1
Restart Current
Sequence
Restart the sequence that contains this
Action definition.
1
Training Sequence
Jam
Modify Modify the Training Sequence Action Jam.
Branch To Destination State
Go to a state in this Sequence.
1
Trigger Output Sends a signal out the trigger port to the
device downstream.
Analyzer Trigger 1. The Action is to send a trigger to the
Analyzer.
2.
The trigger point in the Analyzer that
caused the analyzer trigger action will not
be the selected event, it will be the
selected event with some offset.
External Trigger
Output
The Action is to cause an external trigger
output.
Internal Trigger
Output
The Action is to cause an internal trigger
output.
Marker Trigger Add a marker to captured data.
Capture DWORD Capture DWORD.
Reuse of Captured DWORDs. ( See “Reusing
“Captured DWORDS” in Events” on
page 195. )
Action Description