Teledyne SierraNet M408, User Manual, Page: 63 / 248

SierraNet M408 User Manual 55
Analyzer Settings Teledyne LeCroy
FC Configurations
Figure 2.28: Device Settings dialog for FC devices.
You can manually calibrate the probe settings. Set the parameters for the following:

Cable Type

RX Eq DC gain: Select value from the drop ‐ down list.

RX ‐ 8G Eq DC gain: Select value from the drop ‐ down list.

RX Eq Control: Select value from the drop ‐ down list.

RX ‐ 8G Eq Control: Select value from the drop ‐ down list.

Advanced: Selecting Advanced displays the Advanced Probe Setting dialog with
the RX/TX tab selected. (See Figure 2.29 .) Enter the desired values for each of
the parameters . Select the RX/TX 8G tab (see Figure 2.30 on page 56 ) and enter
the desired values for each of the parameters.

Splitter: Selecting Splitter displays the Splitter Settings dialog. (See Figure 2.31
on page 57 .) Enter the desired values for each of the parameters. Select the 8G
tab (see Figure 2.32 on page 57 ) and enter the desired values for each of the
parameters.

Apply Selected Settings to All: Applies the settings selected in the currently
selected port to all ports in the list.

Import: Loads calibration settings from *.csv file.

Export: Creates a new *.csv file.

Set as Bootup: Loads these settings into memory; rebooting will automatically
load these values.

Restore Factory Settings: Restores factory settings.