Teledyne SierraNet M408, User Manual, Page: 75 / 248

SierraNet M408 User Manual 67
Trigger Filter Settings in Easy Mode Teledyne LeCroy

After the trigger occurs Recording is displayed in the field to the left of the Trig ‐
ger Position indicating the progress of the recording.
Figure 2.44: Post-Trigger.

When recording is complete Uploading is displayed indicating the progress of
the data upload to the host machine.
Figure 2.45: Uploading.
The Recorded Data file appears in the main display window.
Save the file for later use by selecting File > Save .
When a captured trace is not saved and the USB cable is removed, the software displays
an error message that unsaved traces will be closed. If the user ignores the message, and
again plugs in and unplugs the USB cable, the software might get into an unstable state.
When the Ethernet cable is removed, the application detects the event after a delay of
approximately 2.5 to 3 minutes. During this delay the device status remains ready and an
attempt to capture a trace might result in error messages such as :" PCI configuration
failed", or " HAL error". If this occurs, you need to power cycle the analyzer to allow
detecting the device in the device list and continue capturing.
Note:
Spreadsheet View is the default display. However, you can view results in any of the different
views by selecting View on the menu bar and choosing the desired View. The software
remembers the last view (or views combination) used, and will automatically use that next time
it is launched.
Figure 2.46: Typical Spreadsheet View Results Display.
X,Y, T Cursors
Data direction arrows