Tektronix Socket 7 TMS109A, Instruction Manual

Page: 29 / 113

Getting Started
TMS 109A Socket 7 Microprocessor Support
1–13
provided with the probe adapter. Inserting this modified socket into your system
socket will isolate these signals on the probe adapter for use by the ITP cable.
Applying and Removing Power
A power supply for the Socket 7 probe adapter is included with the support. The
power supply pr5 volts power to the probe adapter. The center connector
of the power jack connects to Vcc.
NOTE
. Whenever the system under test is powered off, be sure to remove power
from the probe adapter.
To apply power to the Socket 7 probe adapter and system under test, follow these
steps:
CAUTION. To prevent possible permanent damage to the probe adapter and
Socket 7 microprocessor., use the +5 V power supply provided by Tektronix. Do
not mistake another power supply that looks similar for the +5 V power supply.
1. Connect the +5 V power supply to the jack on the probe adapter. Figure 1–7
shows the location of the jack on the probe adapter.
CAUTION. To prevent possible permanent damage to the Socket 7 microprocessor
and system under test, apply power to the probe adapter before applying power
to your system under.
2. Plug the power supply for the probe adapter into an electrical outlet.
3. Power on the system under test.