Tektronix Socket 7 TMS109A, Instruction Manual

Page: 26 / 113

Getting Started
1–10
TMS 109A Socket 7 Microprocessor Support
CAUTION. To prevent permanent damage to the microprocessor once power is
applied, correctly place the microprocessor into the probe adapter.
12. Insert the microprocessor into the probe adapter as shown in Figure 1–5.
System under test
Microprocessor
Pin A3
Figure 1–5: Inserting a microprocessor into the probe adapter
13. Apply forced air cooling across the probe adapter to keep the components on
the probe adapter cool.
Alternate Connections
NOTE
. Refer to the Intel document ITP700 Port Users Guide for more informa-
tion on the ITP interface.
The Socket 7 probe adapter provides an ITP square-pin header (J580) to connect
to the In-Target Probing (ITP) debugging hardware on the probe adapter as
shown in Figure 1–6 on page 1–12. Table 1–2 lists the signals on the connector
(J580). The ITP debugging hardware is not included with this TMS 109A Sock-
et 7 hardware support package. Contact your microprocessor vendor for
information on how to obtain the ITP debugging hardware.
Insert Microprocessor in
the Probe Adapter
ITP