Tektronix Socket 7 TMS109A, Instruction Manual

Page: 23 / 113

Getting Started
TMS 109A Socket 7 Microprocessor Support
1–7
2. To discharge your stored static electricity, touch the ground connector located
on the back of the logic analyzer. Then, touch any of the ground pins of the
probe adapter to discharge stored static electricity from the probe adapter.
3. Connect the P6434 probes to the probe adapter as shown in Figure 1–2.
Match the channel groups and numbers on the probe labels to the corre-
sponding pins on the probe adapter. Match the ground pins on the probes to
the corresponding pins on the probe adapter.
CAUTION.
To prevent damage to the probe and probe adapter, always position the
probe perpendicular to the mating connector and gently connect the probe.
Incorrect handling of the P6434 probe while connecting it to the probe adapter
can result in damage to the probe or to the mating connector on the probe
adapter.
4. Position the probe tip perpendicular to the mating connector and gently
connect the probe (see Figure 1–2).
Pin 1
Pin 1
Push down to latch after
probe is connected
Push down to latch after
probe is connected
Figure 1–2: Connecting a probe to the probe adapter
5. When connected, push down the latch releases on the probe to set the latch.
6. Follow the procedure from the Socket 7 microprocessor vendor to remove
the microprocessor from the socket on your system under test.
Remove the
Microprocessor