Tektronix DG2020A, User Manual

Page: 192 / 258

UTILITY Menu
DG2020A, P3410, & P3420 User Manual
3Ć91
Sets the baud rate, data length for transmitted data, parity, number of stop bit,
and flow control method for the serial port. These parameters are set to match
the settings of the connected computer.
Base Menu
Item Function
Baudrate Sets the transmission rate for the serial port. A transmission rate of 300,
600, 1200, 2400, 4800, 9600, or 19200 can be set.
Data Bits Sets the data length for the transmitted data. A data length of 7 or 8 bits
can be set.
Parity Sets the kind of parity bit attached to transmitted data. The parity can be
set to None, Even, or Odd.
Stop Bits Sets the number of stop bits. 1 or 2 stop bits can be set.
Handshake Sets the flow control method. Either Off, Soft, or Hard can be set for the
flow control.
Operation:
Set the serial interface parameters
Bottom button Popup menu Side button
System Select the Serial parameter with the up and
down arrow buttons.
Select the item with the left and right arrow
buttons.
Sets whether or not the instrument should wait for key input before starting
operation if a diagnostics error was detected at start up or if no pods are
connected to the instrument. This setting is useful in cases where, for example,
the system is configured with no output pods connected and you do not want the
system waiting for key input.
Operation:
Set the power-on pause
Bottom button Popup menu Side button
System Select Power up Pause with the up and down
arrow buttons.
Select On with the left and right arrow buttons.
Serial
Power up Pause