Tektronix DG2020A, User Manual

Page: 105 / 258

Reference
3Ć4
DG2020A, P3410, & P3420 User Manual
d. Define the control conditions in each line with EDIT Make
Sequence Repeat Count and/or the functions of EDIT Make
Sequence Set Enhanced Control.
Once you have created a pattern data or sequence, configure the hardware of the
DG2020A and set the output parameters.
1. Assign data bits to output channels with SETUP Pod Assign Assign.
2. Set the pulse high and low levels with SETUP Level/Delay.
3. Set the output frequency with the functions of SETUP Oscillator.
Do the following steps to output pattern data.
1. Press the START/STOP button on the front panel to start outputting.
2. Press the START/STOP button again to stop outputting.
Advanced Control for Sequence
Using the event, trigger and run mode, you can control the pattern data output
timing and sequence as your request from the external controller or just pressing
the front panel buttons. For advanced control:
1. Set the trigger wait and/or event jump into each line on the sequence with
the functions of EDIT Make Sequence Set Enhanced Control. See
Sequence described above.
2. Set the trigger parameters with SETUP Trigger.
3. Set the event and/or inhibit parameters with SETUP Pod Control.
4. Set the run mode with SETUP Run Mode.
Setups for Output
Outputs