Tektronix DG2020A, User Manual

Page: 128 / 258

EDIT Menu
DG2020A, P3410, & P3420 User Manual
3Ć27
Changes the name of the block at the current cursor position.
Operation.
Change a block name
Bottom button
Popup menu
Side button
% # # # $!"! && # $ ! # # "!
% # $!"! # # &" " #
# $!!# .
! #!
#! # &
Changes the size of the block at the current cursor position. The size of other
blocks is not changed; the memory size is changed.
When increasing the size of the current block, only set a size that does not cause
the total number of points to exceed the maximum memory size. Zero data
corresponding to the increase in size is added at the end of the block.
When decreasing the size of the current block, data is deleted from the end of the
block.
Note that the range of allowable block sizes starts at a minimum size of 64
points.
. Changes to the block size cannot be reversed with the Undo operation.
#" ! %!
!
'
#!
'
$!!# $!"! "#
Figure 3Ć17: Change a block size
Rename Current Block
Resize Current Block