TECO UA1610, Service Manual

Page: 237 / 388

S-142
(10) SOFT SWITCH: #10
• Bit 8: If this bit set to 1, machine will print out confirmation report after each transaction
for TX/RX RTN signal.
• Bit 7: If this bit is set to1, the result field will show “NG” instead of “OK” in the confirmation
report and activity report or checking the result on the LCD.
• Bit 2: For Manual Tx only.
Bit
No.
Designation Function
Initial
Setting
Bit HEX
8
Print out RTN
page report
0: Not to Print
1: Print Out RTN page report after transaction
for TX/RX RTN signal
1
A
7
Confirmation
report result field
0: Print “OK”
1: Print “NG” in case of sending or receiving RTN
signal
0
6
Get gap time
between digit for
pulse dial
1
5 0
4
RX PIP T.30 com-
mand after send
out MPS com-
mand
0: Send DCS at current speed
1: Return to Tx phase B waiting for DIS signal
0
1
3
Received DIS sig-
nal within recep-
tion
0: Repeat sending DIS/DTC again until time out
1: Disconnected after sending DCN signal
0
2
Transmission time
limitation 0: No any limitation until document jam
1: Limit to 8 minutes from data phase
0
1
Audio alarm after
communication
fail
0: Not to alarm after transaction fail
1: Alarm 3 seconds after disconnected
1
Value 550 ms 650 ms 750 ms 850 ms
Bit 6 0 0 1 1
Bit 5 0 1 0 1
Field_Service_E.book 142 ページ ２００４年２月２５日 水曜日 午後６時５９分