TECO UA1610, Service Manual

Page: 381 / 388

T-1
1. TROUBLESHOOTING
1-1. Troubleshooting Procedure Overview
• If the following symptoms occur when the machine is restarted after the Network Inter-
face Card or the Internet Fax & Network Scan Kit has been mounted, check the board
and connectors for proper connection. If the symptom persists, replace the defective part
or parts.
• If it is not possible to transfer data correctly with the various settings made on [NET-
WORK SETTING], the network or telephone line is probably defective.
NOTE
Network setting and line checks should be made by the network administrator (system
administrator).
1-2. Troubleshooting Procedure Chart
1. If network settings are not correct, check them by following the flowchart below.
The machine does not start up
even if reset is repeated over
and over again.
[NETWORK SETTING] is not
displayed on the “Utility”
screen.
Take necessary action according to the trou-
ble shooting procedures for the machine.
• It takes several minutes for [NETWORK
SETTING] to appear after the power switch
has been turned ON.
• If it does not appear even after you wait for
several seconds, check the Network Inter-
face Card for proper connection. The symp-
tom disappears after the board has been
properly reconnected.
NO
YES
YES
Turn on the power switch
END
NO
Change the Network Interface Card.
NO
Field_Service_E.book 1 ページ ２００４年２月２５日 水曜日 午後６時５９分