TECO UA1610, Service Manual

Page: 54 / 388

D-11
(3) Removal of the Controller/Mechanical Control Board
<Removal Procedures>
1. Remove the Rear Cover.
☞
D-7
2. Remove the Network Interface Card Board. (Option for
UA
1610f)
☞
D-10
3. Remove the Network Control Unit Board. (
UA
1610f only)
☞
D-10
(4) Removal of the Control Panel
1. Remove the Exit tray.
☞
D-7
4. Disconnect all connectors and flat cables from
the Controller/Mechanical Control Board.
NOTES
• The two connectors marked with “*” in the illustra-
tion are provided for
UA
1610f only.
• Use utmost care not to snap off the flat cable.
4980D003AC
*
*
5. Remove six screws.
6. Remove the Controller/Mechanical Control
Board.
4980D004AB
2. Remove the Rubber cap, then remove the three
screws.
3. Unplug one connector and one flat cable.
4. Remove the Control Panel.
NOTE
• Use utmost care not to snap off the flat cable.
4136D047AA
Field_Service_E.book 11 ページ ２００４年２月２５日 水曜日 午後６時５９分