TECO UA1610, Service Manual

Page: 377 / 388

D-2
18. Check that the firmware has been updated properly using the following messages that
should appear.
step 1: Command format is correct
step 2: Program’s header is right
step 4: Flash ROM erase OK
step 5: Flash ROM write OK
step 6: Program complete
19. Input “exit”, and then press the “Enter” key.
C:\>exit
20. Check that you exit the [MS-DOS prompt] or [Command prompt] of PC.
21. Delete the “flash” file created in drive C of the PC.
22. Press the main power switch for the copier OFF/ON to restart the copier.
C:\>ftp XXX.XXX.XXX.XXX
Connected to XXX.XXX.XXX.XXX
220 NET+ARM FTP SERVER X.X ready
USER(XXX.XXX.XXX.XXX:(none)):
230 User none logged in.
ftp>bin
200 Type set to I.
ftp>put X:\XXX.bin
200 PORT command OK.
150 About to open data connection.
226 Transfer complete
ftp: xxxbytes sent in xxxSeconds xxxKbytes/sec.
ftp>get flash
200 PORT command OK.
150 About to open data connection.
226 Transfer complete.
ftp: xxxbytes received in xxxSeconds xxxKbytes/sec.
ftp>quit
221 Goodbye
C:\>type flash
step 1 : Command format is correct
step 2 : Program’s header is right
step 4 : Flash ROM erase OK
step 5 : Flash ROM write OK
step 6 : Program complete
C:\>exit
Field_Service_E.book 2 ページ ２００４年２月２５日 水曜日 午後６時５９分