TechnipFMC Proline Promass F 500, Operating Instructions Manual

Page: 141 / 292

Proline Promass F 500 EtherNet/IP Commissioning
141
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Pulse width In the Operating mode
parameter, the Pulse option is
selected, and one of the
following options is selected in
the
Assign pulse output
parameter (→  140):
• Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
Define time width of the
output pulse. 0.05 to 2 000 ms 100 ms
Failure mode In the Operating mode
parameter, the Pulse option is
selected, and one of the
following options is selected in
the
Assign pulse output
parameter (→  140):
• Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
Define output behavior in
alarm condition. • Actual value
• No pulses No pulses
Invert output signal – Invert the output signal. • No
• Yes No
* Visibility depends on order options or device settings
Configuring the frequency output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode →  142
Terminal number
→  142
Signal mode →  142
Assign frequency output →  143
Minimum frequency value →  144
Maximum frequency value →  144
Measuring value at minimum
frequency →  145