19
121
B
B
B
B
BA
A
A
A
AG F (Contin
G F (Contin
G F (Contin
G F (Contin
G F (Continued)
ued)
ued)
ued)
ued)
27
Step F-7
1. Apply the Self Adhesive Battery Insulation Tape (121) to both
inner edges of the battery compartment on the Chassis (as shown in
Fig. 57) by aligning the cut-outs and edges with the Chassis contours.
Fold the Tape over the top edge the Chassis rails for proper adhesion.
Figure 57
Step F-8
Figure 58
Battery Insulation Tape Install:
Speed Control Install:
1. Cut a piece of Two Sided Tape (156) to the same size as the
bottom of the speed control (
not included).
Peel one side of the back-
ing off and stick the Tape to the bottom of the speed control.
2. Make sure that the area on the left side of the Chassis (19) is
clean. Wipe this area off with a clean cloth or rag.
*NOTE: Rubbing alcohol can be used to clean any oily residue
that may be present on the chassis or receiver. Allow the alcohol to
dry before applying the two-sided Tape.
3. Peel the backing off of the Two Sided Tape and install the
speed control to the left side of the Chassis as shown in Figure 58.
4. Run the wire from the speed control through the slot in the left
rail on the Chassis, across the center of the Chassis, and through the
slot in the right rail of the Chassis.
