110
23
132
55
126
51
122
57
22
B
B
B
B
BA
A
A
A
AG E (Contin
G E (Contin
G E (Contin
G E (Contin
G E (Continued)
ued)
ued)
ued)
ued)
Step E-6
Figure 47
1. Snap a Shock Spring Cup (128) with the small side down,
onto each of the four Shock Shafts (118), (119) and over the Shock
End (120).
2. Slide a Red Shock Spring (131) over all of the Shocks so that
the Spring rests on the Spring Cups.
3. Thread a Shock Spring Adjustment Nut (130), small side down,
on to the top of all four Shock Bodies (125), (126). Thread the Spring
Adjustment Nuts on to the Shocks until the Adjusting Nut just touches
the Spring.
*NOTE: Final ride height adjustment should be made once the
car is fully built and all radio gear and electrics are installed. Refer to
the setup tips provided in the back of this manual for final ride height
adjustment.
Spring Install:
Step E-7
1.Position your car so that the Shock mounting holes in the front
of the Arms are accessible. Make sure that the Dogbones (59) stay in
the Outdrives/ Diff halves (77)(83).
2. Insert a 4-40 x 1/2" Cap Head Screw (57) through the Shock
Mount Ball in one of the rear Shocks. Position the bottom of the
Shock, with the Screw, in front of the Shock mounting area on the left
rear suspension Arm (51). Thread the Screw all the way into the middle
mounting hole in the rear Arm.
4. Slide a short Shock Mount Bushing (132), large side first,
over the Shock mounting Screw (23) in the top left side of the rear
Shock Tower (55).
5. Place the top of the Shock Body (126) over the Shock Mount
Bushing. Secure the Shock and Bushing to the Shock Tower by thread-
ing a 4-40 Locknut (110) onto the Shock Mount Screw.
*NOTE: Before attaching the top of the Shock, make sure that
the Dogbones are in place in the Outdrives.
6. Repeat Steps 2-5 for the right rear Shock.
Rear Shock Install:
110
Figure 48
57
126
119
131
118
128
120
125
130
