55
53
57
9
54
19
Step C-5
Step C-6
Rear Shock Tower Assembly:
Rear Shock Tower Install:
1. Insert two 4-40 x 7/8" Cap Head Screws (23), one on each
side, through the third hole (#3) out on the top of the rear Shock
Tower (55) as shown in Figure 22. Secure the Screws to the Shock
Tower by threading a 4-40 Nut (25) onto each Screw and tightening.
IMPORTANT NOTE:
The Screws should extend from the same
side of the Shock Tower as the two tabs near the center of the Shock
Tower.
2.Thread a silver colored Ball Stud (22) into the inside hole (#1)
on each side of the rear Shock Tower.
IMPORTANT NOTE:
The Ball Stud installed in the rear Shock
Tower, must be a silver colored "Short Neck" Ball Stud.
Figure 22
Figure 23
There is a short Thread-Cutting Screw included in the Wrench
bag. This Screw can be used to tap threads in the holes in the Main
Chassis. Pre-tapping these holes makes it easier to install the Screws
during assembly.
1. Place the rear Shock Tower (55) between the rear Suspension
Arms and against the rear of the Chassis (19) as shown in Figure 23.
The Shock Tower should sit flat against the rear Pivot Plate (53).
Place a Ball Stud Washer (9) over two 4-40 x 1/2" Cap Head Screws
(57). Secure the Shock Tower to the Chassis by threading the two
4-40 x 1/2" Cap Head Screws, with Washers installed, through the
tabs on the Shock Tower and into the Chassis.
2. Secure the rear Shock Tower to the rear Pivot Plate by thread-
ing a 4-40 x 3/8" Flat Head Screw (54) from the bottom side of the
Chassis through the Pivot Plate, and into the Shock Tower.
B
B
B
B
BA
A
A
A
AG C (Contin
G C (Contin
G C (Contin
G C (Contin
G C (Continued)
ued)
ued)
ued)
ued)
23
25
22
54
57
10
22
23
55
25
9
